Accessories, consumables – Hilti TE3000-AVR User Manual
Page 10
2.12 Using extension cords outdoors
When working outdoors, use only extension cords that are approved and correspondingly marked for this
application.
2.13 Using a generator or transformer
This power tool may be powered by a generator or transformer when the following conditions are fulfilled:
The unit must provide a power output in watts of at least twice the value printed on the type identification
plate on the power tool. The operating voltage must remain within +5% and -15% of the rated voltage at all
times, frequency must be in the 50 – 60 Hz range and never above 65 Hz, and the unit must be equipped
with automatic voltage regulation and starting boost. Generators with an inadequate power rating may cause
damage to the power tool.
Never operate other power tools or appliances from the generator or transformer at the same time. Switching
other power tools or appliances on and off may cause undervoltage and / or overvoltage peaks, resulting in
damage to the power tool.
In addition, the power tool may not start or may cut out (no LED indication) if the electric supply is not within
specifications (see “Troubleshooting” section).
3. Accessories, consumables
TPS Theft Protection System with Company Card,
Company Remote and TPS
‑K key (optional)
Use the Hilti chisels or other tools listed below. With these you will achieve higher performance and
longer lifetime as the power tool and chisels have been optimized as a system.
Designation
Width (mm)
Length (mm)
Width in
inches
Length in
inches
Pointed chisels
TE
‑H28P
SM 40
400
16
TE
‑H28P
SM 50
500
20
Flat chisels
TE
‑H28P
FM 40
38
400
1
¹⁄₂
16
TE
‑H28P
FM 50
38
500
1
¹⁄₂
20
Wide-flat chisels
TE
‑H28P
SPM 8/40
80
400
3
¹⁄₈
16
TE
‑H28P
SPM 8/50
80
500
3
¹⁄₈
20
Asphalt chisel
TE
‑H28P
SPMA 45
125
450
5
18
Pointed flat chisel
TE
‑H28P
SPI 50
115
500
4
¹⁄₂
20
Shank
TE
‑H28 SS 40
400
16
Tamping plate
TE STP
150x150
150x150
6x6
TE STP
200x200
200x200
8x8
en
4