Hotpoint WM80 - Manual (Page 10)

IMPORTANT INFORMATION: Before selecting a programme, ensure the mains
button is in the ‘OFF’ position.
Add detergent and or
conditioner to the
dispenser drawer, see
pages 14-15. Refer to
detergent manufacturer’s
dosage instructions.
Select required wash
programme by turning
the wash dial clockwise,
you will hear a click as
the pointer aligns at the
start position.
Select optional wash
features by pressing
button, it will come out.
To cancel, press again
and button will be flush
to the console.
Sort laundry by label
into groups with the
same wash
requirements and
load appliance.
Switch on both the
water & electricity
supply at the mains.
Switch ‘ON’, after a few
seconds the Door Locked
indicator light will
illuminate and the door
will lock. This light will
remain lit throughout
the wash programme.
Close door by applying
pressure at the
3 o’clock position.
1-2 minutes after
completion of the wash
programme the Door
Locked indicator light
will go out and the door
can be opened.
Switch ‘OFF’ after use.
4 5 (Model WM79 only)
Select reduced spin
speed (if required) by
turning the variable spin
speed control dial. 6
1 2 3
7 8 9
Note: We recommend on
completion of your wash
programme that you switch
off both the electricity and
water supply to the
appliance.
WARNINGS
● Do not allow children to
play with the appliance
or tamper with the
controls.
● Do not overload
appliance! It may
damage laundry and
reduce the quality of
the wash.
● Do not attempt to open
the door when the
indicator light is on.
A Typical Wash Programme
10