Husky HD1500 - Manual (Page 19)

19
English
PROBLEM OR CONCERN POSSIBLE CAUSE SOLUTION
Leaking water from bottom
of unit Manifold Assembly is leaking
water Remove the front cover of the unit. If there is
water leaking anywhere from the Manifold
please contact us at customerservice@hus
kypowerwasher.com
or order a replace-
ment directly online at www.huskypowe-
rwasher.com
.
Pump housing is leaking water Email us at customerservice@huskypow
erwasher.com
for assistance.
Low pressure Faucet not fully open or unit is
not receiving a full volume of
water Open the faucet all the way.
Not building maximum
pressure Screen Filter is clogged Clean the Screen filter as instructed in the sec-
tion 6.4.
Irregular pressure Gun or Hose failure Replace Gun and/or Hose. Contact us at c
ustomerservice@huskypowerwasher.
com
or order online at www.huskypowe-
rwasher.com .
Kink in the Garden Hose or Hose
is wrapped on a storage wheel Unwrap the Garden Hose and lay it out flat to
ensure that there are no kinks in the Hose.
Water leaking from either Hose
or Unit Stop water from leaking before using the unit
or contact us if you need assistance.
Garden Hose length is too long Shorten the length of the Garden Hose. We
recommend a maximum length of 25 to 50
feet for City water supply and 30 feet for Well
water supply.
Clogged Nozzle Clean the Nozzle as instructed in section 6.2.
Air in Pump Let Pressure washer run with Gun trigger de-
pressed and Wand removed until a steady
stream of water is released.
No Wand attached to the front
of the Gun Attach either the Turbo or Adjustable Wand to
the front of the Gun. (High Pressure is created
with the Wand and not the Gun).
No water coming out of
Wand Clogged Nozzle Clean Nozzle as instructed in section 6.2.
Quick Connect is attached in-
correctly To Attach Quick Connect properly, keep the
outer collar of the Quick Connect held back
while sliding the Quick Connect all the way
forward against the Inlet Nipple and then re-
lease the collar to lock it into place. (The collar
is spring loaded so if it is released too soon it
will not lock into place).
Sceen Filter is clogged Clean the Sceen filter as instructed in section 6.4.
Kink in the Garden Hose or
Hose is wrapped on a storage
wheel Unwrap the Garden Hose and lay it out flat to
ensure that there are no kinks in the Hose.