Hotpoint DWF61 - Manual (Page 5)

CONNECT TO A DRAINAGE SYSTEM...
WARNING
● Connect your dishwasher drain hose to
pipes which connect to the foul drain
system, and not to surface water drains.
IMPORTANT NOTES For the correct
operation of your dishwasher, it is
essential to comply with the following
information.
Standpipe
Fit the hose to the standpipe
hook which can be found in
the machine.
Ensure that the hose is not
pushed too far down the
standpipe.
DO NOT position the stand-
pipe near an electrical outlet.
ENSURE that the drain hose is
routed as shown in the diagram.
The standpipe should be connected to:
a) A discharge stack-pipe
b) An external gulley OR
c) A sink waste.
The standpipe should have a bore of at
least 38mm (1
1 /
2
"). It should be installed as
shown, have a trap fitted and must
discharge into the same drain system as
your household sink.
It must NOT be connected to a surface
water drain.
Sink Waste System
For under sink drainage:
Before connecting the drain hose,
remove any internal restrictions - This
will prevent a build up of debris which
could cause a blockage.
Remove any restrictions from the waste
spigot and ensure that the sealing
bung is removed. The hose should be
routed, such that it is raised to a
minimum height of 800mm (3
1 /
2
")
Note: Ensure the sink outlet pipe has a
minimum diameter of 32mm.
1. Untie the end of the GREY drainage
hose from the rear of the appliance.
2. Reposition ‘Hooked End Support’ as
required along GREY drainage hose.
3. If fitting an under sink waste disposal
unit, cut out the membrane, bung or
blanking plug.
4. Attach the GREY drainage hose to
the under sink waste disposal unit
securely, using the clip and rubber
tube supplied.
Ensure the drain hose is securely attached,
to prevent it coming away while the
machine is in use and causing a flood.
Installation...
5
120
min