Harbor Freight Tools 91332 - Manual (Page 5)

SKU 91332 Page 5
Operation
Battery Precautions
1. To avoid accidents, only charge the supplied batteries. Do not use a different
charger adapter with this tool.
2. Do not expose the battery to rain or wet conditions.
3. To avoid damage of cable and plug, never pull the cable to disconnect the
charger.
4. Do not charge the battery if either the cable or plug are damaged.
5. Repairs should be carried out by a qualified technician only.
6. Do not touch the battery poles with any conductive source.
7. Do not store the battery in a box with other metal objects.
8. Do not throw the battery in a fire.
Charging the Battery
The internal Battery does not come charged from the factory. Charge before
using.
1. Insert the Charger Adapter module plug into the unit connector as shown
below.
2. Plug the Charger Adapter module into an electrical outlet.
The red LED on the cordless Screwdriver will light. Charge the new battery
from 5 to 7 hours. Battery usage time will ramp up as the new Battery is
used, and recharged. Do not overcharge the battery.
Caution: Never charge Battery for more than 7 hours continuously. Charger
Adapter should not be left plugged in or charging for more than 7 hours.
Note: Never over-discharge a battery by using the tool
even after tool performance is decreasing. Severe heat
is most destructive to a battery; the more heat
generated, the faster the battery loses power.
A battery that gets too hot can be permanently
damaged. Never attempt to discharge a tool’s
battery by continuing to pull the tool trigger.
When tool performance begins to diminish, stop
the tool and re-charge the battery for optimal performance.