Harbor Freight Tools Pittsburgh Automotive 2WD and 4WD Ball Joint Service Kit 4065 - Manual (Page 2)

Page 2 For technical questions, please call 1-800-444-3353. Item 4065
WARNING SYMBOLS AND DEFINITIONS
This is the safety alert symbol. It is used to alert you to potential personal injury hazards.
Obey all safety messages that follow this symbol to avoid possible injury or death.
Indicates a hazardous situation which, if not avoided,
will result in death or serious injury.
Indicates a hazardous situation which, if not avoided,
could result in death or serious injury.
Indicates a hazardous situation which, if not avoided,
could result in minor or moderate injury.
Addresses practices not related to personal injury.
IMPORTANT SAFETY INFORMATION
WARNING Read all safety warnings and instructions.
Failure to follow the warnings and instructions may result in serious injury.
Save all warnings and instructions for future reference.
1. Keep children and bystanders away
while operating. Distractions can
cause you to lose control.
2. Keep work area clean and well lit.
Cluttered or dark areas invite accidents.
3. Wear ANSI-approved safety goggles, NIOSH-
approved dust mask/respirator, and heavy-
duty work gloves during use and service.
4. Stay alert and use common sense when
operating. Do not use when tired or under the
influence of drugs, alcohol or medication.
5. Do not overreach. Keep proper footing
and balance at all times. This enables
better control in unexpected situations.
6. Dress properly. Do not wear loose clothing or
jewelry. Keep your hair, clothing and gloves
away from moving parts. Loose clothes, jewelry
or long hair can be caught in moving parts.
7. This product is not a toy. Keep it out
of reach of children.
8. Use the correct product for the correct
vehicle. The correct product will do the job
better and safer at the rate for which it was
designed. Do not modify this product or use
it for a purpose for which it is not intended.
9. Check for misalignment or binding of moving parts,
breakage of parts and any other condition that
may affect the product’s operation. If damaged,
have the product repaired before use.
10. Use the product and accessories etc., in accordance
with these instructions and in the manner intended
for the particular type of product, taking into account
the working conditions and the work to be performed.
Use of the product for operations different from those
intended could result in a hazardous situation.
11. Have product serviced by a qualified repair person
using only identical replacement parts. This will
ensure that the safety of the product is maintained.
12. Maintain labels and nameplates on the
product. These carry important safety
information. If unreadable or missing, contact
Harbor Freight Tools for a replacement.
13. This product contains or, when used, produces a
chemical known to the State of California to cause
cancer and birth defects or other reproductive harm.
(California Health & Safety Code § 25249.5, et seq.)
14. Use caution when applying a load. Slowly and
carefully apply pressure to the vehicle part being
pressed. If the workpiece seems unusually hard
to press, immediately stop the operation. Carefully
disconnect the Ball Joint Kit from the workpiece, and
adjust the Ball Joint Kit to eliminate or diminish an
off-center load. Then, continue with the procedure.
15. Do not use the Ball Joint Kit to compress
springs or any other item that could
disengage and cause a potential hazard.