Hotpoint FZM80 - Manual (Page 14)

Door Reversal
14
You will need a cross head screwdriver, a flat blade screwdriver and a 5mm spanner to
carry out this procedure.
Our Service Department can arrange for an Engineer to do the conversion for you but
a charge will be made.
WARNING: Switch off electrical supply and pull out the mains plug.
Remove all loose fittings from inside the freezer.
If you have previously set up and used the freezer and since decided to reverse the
doors, you must remove stored food, wrap or cover it and place into insulated
containers to keep frozen whilst carrying out this operation.
1. Open the door as wide as possible.
Note : You may require assistance to do this:
2. Support the door and using a screwdriver, remove the screw
securing the top hinge.
3. Lower the top hinge and carefully tilt the door to remove the
hinge from the cabinet. Lift the door off the bottom hinge.
4. Remove the top hinge from the door.
5. Remove the spacing washers from the right hand bottom hinge pin.
7. Unscrew the fixing
screw to remove the
right hand hinge cover
plate.
(if applicable) Remove
the door stop washer, if
fitted to your model.
11. (if applicable) Put the
door stop washer in
position on the left
hand hinge bracket, if
fitted to your model.
Screw in the hinge pin.
6. Use a flat blade
screwdriver or a 5mm
spanner, to unscrew
and remove the
bottom hinge pin.
8. Replace the right hand
cover plate with its
original screw.
12. Replace the left hand
cover plate with its
original screw.
13. Place the spacing
washers onto the left
hand bottom hinge
pin.
9. Take the plastic cap
from the left hand
cover plate and use it
to fill the hole on the
right hand cover plate.
10. Unscrew the fixing screw to remove the left hand hinge cover plate.
CLEANING &
MAINTENANCE