HONDA 2008 Accord Coupe - Manual (Page 332)

To change the bulb, start the
engine, turn the steering wheel all
the way to the right, then turn off
the engine.
Use a flat-tipped screwdriver to
remove the two holding clips from
the inner fender, and pull the inner
fender cover back.
Insert the new bulb into the hole,
and turn it one-quarter turn
clockwise to lock it in place.
Push the electrical connector back
onto the bulb. Make sure it is on
all the way.
Reinstall the under cover and put
the three fasteners back in place.
Reinstall the inner fender. Make
sure it is installed under the edge
of the front bumper.
Reinstall the holding clips, and
push in its head of each clip.
Remove the electrical connector
from the bulb by pushing on the
tab and pulling the connector
down.
Remove the bulb from the fog
light assembly by turning it one-
quarter turn counterclockwise.
Turn on the fog lights to test the
new bulb.
6.
7.
8.
4.
5.
9.
10.
11. Passenger’s side
Driver’s side
Driver’s side
Lights
Ma
int
e
na
nce
329
HOLDING CLIPS
ELECTRICAL CONNECTOR
TAB
2008 Accord Coupe
Table Of Contents Main Menu