Troubleshooting – Hotpoint HMT40 User Manual
Page 17
17
GB
TROUBLESHOOTING
The display is completely switched off
Check that:
O
The mains switch in your home is on.
O
There has not been a power cut.
O
The plug is properly inserted in the socket and is switched
on.
O
The socket is working; try another appliance in the socket
to check.
O
The fuse in the plug is ok - if not replace it,
(see ELECTRICAL CONNECTION).
The motor does not start
Check that:
O
O
O
O
O
8 minutes have passed since you switched the appliance
on?
This model is provided with a motor protection control system
which means that it will only start approximately 8 minutes
after being switched on.
The refrigerator and the freezer do not
cool properly.
Check that:
O
The doors close well and that the seals are not damaged
O
The doors have not been left open too long.
O
The temperature settings are correct.
O
The refrigerator or freezer is not overfilled.
The food inside the refrigerator is too cold
Check that:
O
the temperature is on the best setting.
O
The food is not in contact with the back wall - which is the
coldest part.
The motor runs constantly
Check that:
O
the SUPER COOL and/or SUPER FREEZE and/or
ICE PARTY
functions are enabled.
O
the temperature settings are correct.
O
the doors have not been open continuously.
O
The room temperature is too high.
The appliance makes too much noise.
The gas refrigerant produces a slight noise even when the
compressor is not running (this is not a defect).
Check that:
O
The appliance is level.
O
The appliance was installed between cabinets or objects
that vibrate and make noise.
If after all the checks, the appliance still does not operate or
the problem persists, call Hotpoint Service (see KEY
CONTACTS, back page) and inform them of: the type of
problem, the abbreviation of the model name (Mod.) and the
relative numbers (S/N) written on the rating plate located at
the bottom left of the refrigerator compartment.
Never call on unauthorized technicians and always
refuse spare parts which are not originals.
There is water on the bottom of the
refrigerator.
Check that:
O
The defrost drain is clear from any blockage (fig.7).