Hoover Dubl-Duty - Manual (Page 4)

4
The wall bracket, included with your
cleaner, is designed for both storing and
recharging the cleaner. Choose a con-
venient place where the bracket can be
mounted in a vertical position (with hook
pointing up) and within six feet of an
electrical outlet.
Do not use an outlet
which is controlled with a wall switch
for charging your cleaner.
If bracket will be mounted closer to an
outlet, wrap excess cord around projec-
tions on back of wall bracket.
Press end of cord into notch on bottom
of bracket.
1-3
Mounting wall
bracket
A
1-4
Hold bracket against wall in desired
location and mark center of each hole.
Drill a 1/8” diameter starter hole in cen-
ter of each mark.
If wall bracket is being mounted onto
dry wall, plaster, or thin paneling
backed by dry wall or plaster*,
enlarge
starter holes to 13/64” diameter. Push
plastic anchors fully into holes. Place
bracket on wall over anchors. Begin dri-
ving screws into anchors. Tighten
screws securely.
*Do not attempt to mount wall bracket
onto thin paneling
without a dry wall or
plaster backing.
If wall bracket is being mounted onto
a wall stud, solid wood or thick panel-
ing,
drill only the starter holes. Place
bracket onto the wall and drive screws
into holes without plastic anchors.
1-5
Position crevice tool and squeegee into
deluxe wall bracket as shown.
Charging cleaner
Plug charger into 110/120 volt electrical
outlet.
Before charging, make sure the tools
(deluxe model only) are not attached to
the cleaner.
1-6
Hold cleaner with nozzle pointing down
and opening in handle section aligned
with hook in wall bracket. Slide cleaner
straight down onto hook.
Press firmly
on handle to ensure that end of cord
is fully connected to cleaner.
Your
cleaner will begin charging. It is
designed to be stored on charge and
ready for use at all times.
The batteries will be fully charged in
16 hours.
At this time, the standard
cleaner will have seven minutes of useful
operating time and the deluxe unit, four-
teen minutes. If performance drops to
an unacceptable level during time,
check problem chart in “Maintenance”
section.
NOTE: It is normal for the charger to
feel warm when the battery is charging.
Never charge batteries in temperatures
above 100
0 F or below 32 0 F.