Harbor Freight Tools 95028 - Manual (Page 4)

Page 4 SKU 95028 For technical questions, please call 1-800-444-3353
Unpacking
When unpacking, check to make sure the parts listed on page 7 are included. If any
parts are missing or broken, please call Harbor Freight Tools at the number on the cover of
this manual as soon as possible.
For best service, you should incorporate an oiler, regulator, and inline filter, as shown
in the diagram above. Hoses, couplers, oilers, regulators, and filters are all available
at Harbor Freight Tools.
Assembly and Operating Instructions
19. Industrial applications must follow OSHA requirements.
20. Warning: Use 3” Cutting disc. Only use a standard 3” cutting disc (rated at
20,000 RPM or greater) with this Cut-Off Tool. never use any other kind of disc,
blade or cutter. do not bind the cut-off wheel/disc.
21. Warning: Some dust created by power sanding, sawing, grinding, drilling
and other construction activities contain chemicals known (to the State of
California) to cause cancer, birth defects or other reproductive harm. Some
examples of these chemicals are: lead from lead-based paints, crystalline silica
from bricks and cement or other masonry products, arsenic and chromium
from chemically treated lumber. Your risk from these exposures varies,
depending on how often you do this type of work. To reduce your exposure to
these chemicals: work in a well ventilated area and work with approved safety
equipment, such as those dust masks that are specifically designed to filter out
microscopic particles (California Health & Safety Code 25249.5, et seq.)
Cut-Off
Tool