HandHeld Entertainment Quick Check ImageData Barcode Verifier Quick Check 890 - Manual (Page 19)

Quick Check® 890 User’s Guide 3 - 3
illumination will turn off. If the calibration process is successful, the following
screen displays:
4. Enter your name and the location where the calibration was performed and
click on OK. The following screen displays:
5. If the unit does not calibrate, contact Hand Held Products Technical Support
(see Technical Assistance on page 5-1).
To access calibration logs, go to Settings->Calibration->Calibration Log.
Enter the password visions07.
Scanning Properly Using a Pen/Mouse Wand
Note: It is important to perform reflectance calibration prior to using any pen or
mouse wand. See "Calibrating an External Pen/Mouse Wand" on page
3-4 .
1. Turn on the verifier and confirm that the pen/mouse wand is securely
connected.
2. Hold the pen wand as you would a pen or pencil, placing your fingers on
each side of the foot near the tip:
or