Harbor Freight Tools CENTRAL PNEUMATIC 95499 - Manual (Page 11)

Page 11 SKU 95499 for technical questions, please call 1-800-444-3353.
to Stop the Compressor:
Push down on the Pressure Switch (63) to its 1. “StOP” position. (See figure f.)
Unplug the Air Compressor from its electrical outlet. 2.
Squeeze the trigger on the pneumatic tool to release any remaining air pressure 3.
from the tool. Then disconnect the air hose from the tool, and store the tool in a
clean, dry, safe location out of reach of children. Turn the Air Outlet Valve (67) to its
closed position.
Disconnect the other end of the air hose from the Compressor’s Air Outlet Valve 4.
(67), and store the air hose in a clean, dry, safe location out of reach of children.
Pull out on the Safety Release Valve (61) to release all remaining air pressure from 5.
the Air Tank (50). (See figure f.)
Remove any moisture in the Air Tank (50) by opening the Tank Drain Valve (54). 6.
Then, retighten the Drain Valve. (See figure f.)
Allow the Air Compressor to completely cool. Then store the unit in a clean, dry, 7.
safe location out of reach of children.
INSPECtION, MAINtENANCE, ANd CLEANING
WARNING! 1. Make sure the Pressure Switch (63) of the Air Compressor is in its
“StOP” position and the unit is unplugged from its electrical outlet before perform-
ing any inspection, maintenance, or cleaning procedures or leaving it unattended.
before each use, 2. inspect the general condition of the Air Compressor. Check for
loose screws, misalignment or binding of moving parts, cracked or broken parts,
damaged electrical wiring, loose air fittings, and any other condition that may affect
the safe operation of the Compressor. If abnormal noise or vibration occurs, have
the problem corrected before further use.
do not use damaged equipment.
before each use, 3. check the compressor oil level in the Oil Sight Glass (21). If
necessary, fill the crankcase of the Air Compressor with the proper amount and
type of compressor oil.
daily, 4. purge the Air Tank (50) of all air and moisture to prevent corrosion. To do so,
slowly and carefully unscrew (no more than four threads) the Tank Drain Valve (54)
until the compressed air and condensation begins to be released from the Tanks.
Allow sufficient time for all of the air and condensation to escape from the Tanks.
Then, firmly re-tighten the Drain Valve.
CAutION! All maintenance, service, or repairs not mentioned in this manual 5.
must only be performed by a qualified service technician.