Hitachi C 6DC2 - Manual (Page 22)

English
22
(3) Ensure that the switch is turned to the ON
position before the saw blade comes in
contact with the lumber. The switch is
turned ON when the trigger is squeezed;
and OFF when the trigger is released.
Moving the saw straight at a constant
speed will produce optimum cutting.
CAUTION:
● Before starting to saw, ensure that
the saw blade has reached full speed
revolution.
● Should the saw blade be stopped or
made an abnormal noise during op-
eration, turn off the switch immedi-
ately.
● When finished with a job, pull out the
battery from the main body.
● Twisting and forcibly pressing the
saw during cutting can result in un-
reasonable pressure on the motor, so
try to go straight quietly.
● In the situation where the circular
saw is continuously operated while
replacing the battery with stocked
spare batteries one after another, the
motor tends to overheat. Therefore,
whenever the housing becomes hot,
give the saw a break for a while.
● Avoid cutting operation in a state
where the base bottom is afloat from
the material being cut. Otherwise,
the motor can get locked.
MOUNTING AND DISMOUNTING THE SAW BLADE
CAUTION:
To avoid serious accident, ensure the switch is in the OFF position, and pull out the
battery.
Fig. 16
Fig. 17
45
3
0
1
5
0
0 45˚
Base
Wing-Nut
Inclined Gauge
Bevel Plate
Wing-Nut
Inclined
Gauge
Cutting line
(at 45 degrees)