haier HWM70-928NZP - Manual (Page 9)

9
Connection between the water inlet hose jointer and the water
faucet
Install the water inlet hose
Confirm the water faucet
Water tap, suitable
Outlet end surface
>10mm
Water tap, not suitable
It is required that the front end shall be longer than 10mm.
The outlet end surface of the tap shall be flat and smooth. If not please file it to avoid
leakage.
Press the lower end of the lock lever and push down the slider. Take off the water inlet 1.
hose jointer from the water inlet hose component. See to Figure 1.
Loosen the screw till the water faucet can be accessed. Put the jointer of the water 2.
inlet hose on the faucet. See to Figure 2.
(If the faucet is too large and the jointer can not be set on the water faucet, please
loosen the four screws and take out the bushing in the jointer. The front end of the
faucet must be smooth, otherwise it may leak water. See to Figure 3.)
Figure 1
Lock lever
water inlet
hose jointer
Slider
water inlet hose
Figure 2
Screw knife
Sign plate
Figure 3
Screw
Bushing
Fasten the four screws evenly. See to Figure 4. 3.
Take off the nameplate. Twist the fastening nut as per the indication of the figure to 4.
seal up the exit end face of the faucet. See to Figure 5.
Remarks: Before installation, the threading is 4mm above the upper surface of the nut.
After installation, the threading is 2mm above the upper surface of the nut.
See to figure 6.
Figure 4 Figure 5
Nut
Figure 6
About 4mm before twisting
About below 2mm after twisting