haier HWM70-928NZP - Manual (Page 7)

7
The drainage shall be smooth with the drain
hose.
Usage of the drain hose
<10cm
1. The height of the drain hose shall be less
than 10cm, or the drainage will not be
smooth, and cost such long time that the
machine may stop at mid way.
3. If the drain hose is too long, cut it at mid
point. To make smooth drainage, cut the
front end of the hose slantingly.
4. If extra drain hose is needed, please
make separate purchase. The inner
diameter of the extra hose shall not
less than 30 mm, and the length shall
not exceed 1.5 m.
4. If the extra hose is too long, cut it
either at A or at B.
2. Do not step on or press the drain hose. <1.5m
> 30mm
Adjust the adjustable foot: ●
To adjust the washing machine, please first
lift up the front of the machine slightly, then
twist the adjustable foot on the both side.
The largest allowed slope of the
shank base of the machine is 2°. The
slanting or rough ground will result
in unstable running or stoppage of
the machine. Please adjust it with
following methods:
Adjust the installation position
Confirm it’s horizontal: ●
Hang the lead line to check if
it is horizontal.
+LJK /RZ