Humminbird PIRANHAMAX 190CPT - Manual (Page 14)

5.
Assembling the Portable Case
In this procedure, you will install the base assembly into the portable case.
1. Unzip the largest opening on the front of the portable case.
2. Insert the base assembly into the portable case, so that the
PiranhaMAX™ control head is facing out of the case. For best results,
pull the case over one shoulder of the handle at a time.
3. Adjust the case so that you can easily grab the handle, through the
fabric handhold inset, from the outside top of the portable case.
Installing the Base into the Case Pulling the Case over the Handle Holding the Portable Case
8