Honeywell TS815 - Manual (Page 15)

29
29
tower icon will start flashing next to the clock icon. If reception is
disabled, the triangular tower icon will disappear.
Icon Atomic Time Reception Strength
(Flashing)
Undefined data
Reception failed for the past 24 hours
Weak signal, but can be decoded
Strong signal
SUNRISE/SUNSET WINDOW
The main unit is able to calculate the sunrise and sunset times depending on
the user defined location. The location data contains the longitude, latitude,
time zone and DST (Daylight Saving Time).
If the closest city code is selected, the main unit will automatically generate all
of the correct data for specified location.
If you cannot find the closest city code or would like to enter your specific
location, select “USR” as the city code during the setup.
A search function is also available. It allows viewing the sunrise/sunset times
for different dates.
ACCESSING SUNRISE/SUNSET WINDOW
Press UP or DOWN until the sunrise and sunset icons
on the lower
left of the display will start flashing.
30
PROGRAMMING YOUR LOCATION
• In Sunrise/Sunset Window, press and hold SET until the city code in
the Clock Window will flash entering the location programming mode.
• Select the city code closest to your area by pressing the UP or DOWN.
Refer to P. for a list of available codes. The corresponding longitude
and latitude will be displayed in Sunrise/Sunset Window along with the
city code.
• If you wish to enter the geographical coordinates yourself, select the
“USR” (user) as a city code.
• Press SET to confirm your selection and enter into the geographical
coordinates programming mode – the latitude degrees will flash
PROGRAMMING LATITUDE, LONGITUDE, TIME ZONE AND DST
• Press UP or DOWN to adjust the digits. Press and hold either button
for fast advance.
• Press SET to confirm your selection.
• Repeat above procedure to set latitude and longitude minutes,
longitude degrees, time zone, and DST selection.
• Once programming is completed, the display will return to the
Sunrise/Sunset Window.
VIEWING LOCATION DATA
In Sunrise/Sunset Window press SET selecting either:
• Time and sunrise/sunset times
• Calendar and sunrise/sunset times
• Calendar and longitude/latitude