Honeywell TS815 - Manual (Page 13)

25
25
format, hour and minutes
• Press SET every time to confirm each selection and move to the next
MANUAL PROGRAMMING
• In the Clock Window, press and hold SET button until the day of week
language abbreviation “ENG” will flash
• Press the UP or DOWN selecting the day of the week in English,
German, French, Italian, Spanish or Dutch
• Press SET to confirm selection
• Select the code USR by pressing UP or DOWN
• Press SET to confirm selection and enter to the latitude and longitude
setting mode (the degrees of latitude will flash)
• Press UP or DOWN to adjust the latitude (degrees, minutes and
direction). Press and hold either button for quick digits advance
• Press SET to confirm the selection
• Continue setting the longitude (degrees, minutes and direction) using
the same technique
• Press SET to confirm the selection – 0:00 + tz” will flash prompting to
enter the Time Zone setting mode (the Time Zone data is provided on
P.)
• Set the Time Zone by pressing UP or DOWN to adjust the time in 30
min intervals. Press and hold either button for quick digits advance
• Press SET to confirm selection – DST no”” will flash prompting to set
the Daylight Saving Time Option
• Press UP to enable and DOWN to disable the DST option
• Press SET to confirm selection and the year digits will flash
• Continue setting the year, month, day, calendar format (day/month or
month/day), time format (12 or 24 hours), local hour and minutes, using
26
the same technique
After programming is complete the display will return to the default Clock
Window.
Note: Press and hold SET anytime during the setup to return to the default
Clock Window and all previous settings will be cancelled.
DIFFERENT CLOCK AND CALENDAR MODES
In the Clock Window press SET selecting either:
• Hour and Minutes with the Day of the week
• Hour and Minutes with the City Code
• Hour and Minutes with the Seconds
• Month with the day and a year
• Hour and Minutes for UTC (Coordinated Universal Time)
ACTIVATING OR DEACTIVATING ALARMS
• Press the ALARM to display the Weekday Alarm (W), Single Alarm (S)
or Ice Warning Alarm (Pre-Al) time. If these alarms are not set, the
abbreviation OFF will be displayed
• To enable or disable any of these alarms, press UP or DOWN
Note: Press SET anytime during alarm selection mode to return to the default
clock display.
PROGRAMMING ALARMS
• In the Clock and Alarm Mode, press the ALARM selecting the desired
alarm – W, S or PRE-AL
• Press and hold ALARM button until the hour digit will flash
• Set the alarm hour using the UP or DOWN. Press and hold either
button for quick digit advance