Harbor Freight Tools CENTRAL PNEUMATIC 53177 - Manual (Page 10)

Page 10 For technical questions, please call 1-800-444-3353. Item 53177
SAFET
y
Op
ERA
TION
M
AINTENAN
c
E
SETU
p
Operating Instructions
Read the ENTIRE IMpORTANT SAFETy INFORMATION yy section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
Inspect tool before use, looking for damaged, loose, and missing parts.
If any problems are found, do not use tool until repaired.
Tool Set Up
TO pREVENT SERIOUS INJURy REVENT SERIOUS INJUR REVENT SERIOUS INJUR FROM A yy ccIDENTAL OpERATION:
Turn off the tool, detach the air supply, safely discharge any residual air pressure
in the tool, and release the throttle and/or turn the switch to its off position before
performing any inspection, maintenance, or cleaning procedures.
TO pREVENT SERIOUS INJURy REVENT SERIOUS INJUR REVENT SERIOUS INJUR :
Do not adjust or tamper with any control or component in a way not specifically explained within
this manual. Improper adjustment can result in tool failure or other serious hazards.
WARNING! Do not use with cutoff wheels, saws or
any attachment that requires a safety guard.
This tool does not have a safety guard.
1. Select the Grinding Mounted Stone
attachment appropriate for your needs.
2. Use the Wrench to hold the Spindle in
place, while using the other Wrench to
loosen and remove the Collet Nut.
3. Insert the shaft of the Grinding Mounted
Stone into the Collet. Reassemble
the Collet Nut on the Spindle.
4. Use both Wrenches to tighten.
Workpiece and Work Area Set Up
1. Designate a work area that is clean and well-lit.
The work area must not allow access by children
or pets to prevent distraction and injury.
2. Route the air hose along a safe route to reach
the work area without creating a tripping hazard
or exposing the air hose to possible damage.
The air hose must be long enough to reach
the work area with enough extra length to
allow free movement while working.
3. Secure loose workpieces using a vise or clamps
(not included) to prevent movement while working.
4. There must not be hazardous objects
(such as utility lines or foreign objects) nearby
that will present a hazard while working.