Hitachi 50EX8K/10B - Manual (Page 21)

USING THE GENIUS REMOTE TO CONTROL VCR FUNCTIONS
21
USING THE GENIUS REMOTE TO CONTROL VCR FUNCTIONS
• To operate your VCR, point the Genius remote at the remote sensor of
the VCR.
The Genius remote is designed to operate different types of VCR's. You
must first program the Genius remote to match the remote system of your
VCR. (Refer to Table 1 on page 18).
(1) Turn ON your VCR.
(2) Set the Multi-Page select switch on the Genius remote to VCR.
(3) AIM the Genius remote at the front of your VCR.
(4) While holding down the SELECT button, press the button that matches
your VCR as shown on page 18. The channels on the VCR will begin
changing after 5 seconds when the correct button is pressed. When this
happens the Genius Remote control is programmed for your VCR. If the
VCR channels do not change after 5 seconds, try a different Genius
Remote button.
(5) Release both buttons when the VCR starts to change channels. The
precoded VCR buttons will now control your VCR.
NOTES:
• If your VCR cannot be operated after performing the above procedures, the
codes have not been precoded into the Genius remote control and it will not
be able to operate your VCR.
• You will only have to program your remote control to match your VCR once.
The remote will remember the codes until you replace the batteries.
• Whenever you install or replace batteries in the Genius remote, you must
reprogram the Genius remote to match the remote system of your VCR.
• When operating your TV or a cable box, remember to set the Multi-Page
select switch to the proper position.
• Refer to the instruction manual for the VCR to operate buttons exclusively
for the VCR.
• Be sure to keep the original remote control for the VCR even if you use the
Hitachi Genius remote to control your VCR.