beautypg.com

Radiant surface units, Leveling the range – Hotpoint LEB356 User Manual

Page 7

background image

7

Safety Instructions

Operating Instructions

Care and Cleaning

Troubleshooting T

ips

Customer Service

Leveling screws are located on each corner of

the base of the range. Remove the bottom

drawer and you can level the range on an

uneven floor with the use of a nutdriver.
To remove the drawer, pull the drawer out all

the way, tilt up the front and take it out. To

replace the drawer, insert glides at back of

the drawer beyond stop on the range glides.

Lift drawer if necessary to insert easily. Let the

front of drawer down, then push in to close.

One of the rear leveling screws will engage

the Anti-Tip device. Allow for some side to

side adjustment. Allow a minimum clearance

of 1/8

between the range and the leveling

screw that is to be installed into the Anti-Tip

device.

LEVELING THE RANGE

Avoid scratching the glass cooktop. The

cooktop can be scratched with items such

as sharp instruments, rings or other jewelry

and rivets on clothing.

Do not operate the radiant surface units if

the glass is broken. Spillovers or cleaning

solution may penetrate a broken cooktop

and create a risk of electrical shock.

Contact a qualified technician immediately

should your glass cooktop become broken.

Never use the glass cooktop surface as a

cutting board.

Do not place or store items that can melt or

catch fire on the glass cooktop, even when

it is not being used.

Be careful when placing spoons or other

stirring utensils on glass cooktop surface

when it is in use. They may become hot and

could cause burns.

Do not stand on the glass cooktop. The

weight may cause the top to break.

Avoid heating an empty pan. Doing so may

damage the cooktop and the pan.

Clean the cooktop with caution. If a wet

sponge or cloth is used to wipe spills on a

hot surface unit, be careful to avoid steam

burns. Some cleaners can produce noxious

fumes if applied to a hot surface.

NOTE:

We recommend that you avoid

wiping any surface unit areas until they

have cooled and the indicator light has

gone off. Sugar spills are the exception to

this. Please see Cleaning the glass cooktop

section.

When the cooktop is cool, use only the

recommended cleaning cream to clean the

cooktop.

To avoid possible damage to the cooking

surface, do not apply cleaning cream to the

glass surface when it is hot.

After cleaning, use a dry cloth or paper

towel to remove all cleaning cream residue.

Read and follow all instructions and

warnings on the cleaning cream labels.

RADIANT SURFACE UNITS

Read and follow this Safety Information carefully.
SAVE THESE INSTRUCTIONS

Use care when touching the cooktop. The glass surface of the cooktop will retain heat after the
controls have been turned off.

This manual is related to the following products: