Harbor Freight Tools 96456 - Manual (Page 7)

Page 7 SKU 96456 For technical questions, please call 1-800-444-3353.
ASSeMBlY
Your road sweeper is shipped assembled, except for adjustment of the handle
and initial service of tires and engine.
check the wheels
Check the Wheels for proper function and adjust if needed.
Check the Wheel air pressure, and fill to no more than 30 PSI cold.
Adjusting the Handle
Loosen the Handle Screw Knobs (74) to loosen the Upper Handle (76).
Pull the Upper Handle (76) upward into position. Tighten Handle Screw Knobs
(74) securely.
Recheck all bolts and fasteners periodically before work to ensure the assembly
remains secure and safe.
MAndAtOrY MAintenAnce BeFOre FirSt uSe
wArning: The road sweeper is shipped without oil in engine, and without gasoline
in the engine fuel tank. You must add oil and fuel before first use of this tool. Serious
damage to the tool will result if it is not properly serviced before first use.
initial engine Service
For complete engine operating instructions, see the engine manufacturer’s
owners manual shipped with this product.
cAutiOn: to prevent accidental starting, remove the spark plug wire
before working on the engine.
cAutiOn: the engine is shipped without oil or gasoline. You must fill engine
oil reservoir before starting the engine for the first time. Operating the engine
without oil will result in almost immediate severe damage to the engine.
To add or check oil level (engine must always be OFF), unscrew Oil Dipstick
which is attached to the cap of the Oil Fill Port. Oil level on dipstick should be
between the ADD and FULL marks. If oil level is unclear, wipe dipstick with
a clean rag, insert dipstick into opening and turn screw cap until finger tight.
Unscrew cap and remove dipstick and read oil level.
Prior to first use, unscrew Oil Fill Port and add approximately 3/4 quart SAE
30 weight non-detergent motor oil into opening. Use a suitable clean funnel to
prevent oil spills.
1.
2.
1.
2.
3.
1.
2.
3.
4.