Philips HI518 - Manual (Page 10)

C
1 Press the turbo-steam button and hold it down for max.
5 seconds.
2 Release the button and wait at least 1 minute before using the
turbo-steam function again.
Drip stop
This iron is equipped with a drip-stop function: the iron automatically
stops producing steam when the temperature is too low to prevent
water from dripping out of the soleplate. When this happens you may
hear a click.
◗ Set the temperature dial to a position that is suitable for steam
ironing ( 2 to MAX). Make sure that the steam setting you select
is suitable for the ironing temperature selected (see 'Steam
ironing' in chapter 'Using the appliance').
The iron will start steaming as soon as the set temperature has been
reached.
Electronic safety shut-off function
B Type HI545 only
The electronic safety shut-off function automatically switches the iron
off if it has not been moved for a while.
C
◗ To indicate that the heating element has been switched off, the
red auto-off pilot light will start blinking and you will hear an
audible signal.
- When the iron is in horizontal position, this will happen after 30
seconds.
- When the iron is in vertical position, this will happen after 8 minutes.
To let the iron heat up again:
- Pick up the iron or move it slightly.
- The red auto-off pilot light goes out and the amber temperature
pilot light goes on.
- The iron is ready for use when the amber pilot light has gone out.
ENGLISH 10
HI 545
4239 000 44177 28-09-2004 11:52 Pagina 10