Harbor Freight Tools 90193 - Manual (Page 5)

Page 5
SKU 90193
Operation (continued)
Warning! Do not load a nail into the Nailer until you are ready to work.
Caution: Do not point the Nailer toward any person, pet, or toward yourself.
Immediately after finishing work, disconnect the Nailer from the air source.
Caution: After it is disconnected, the Nailer may still hold enough residual air charge
to fire a nail. With the Guide Box pressed against a solid surface, press down on the
top of the Nailer several times to expel any residual air charge.
4. Holding an 8D, 9/32” nail by the stem (not the tip), insert the head of the nail into the
Guide Box (#18), and grip your palm over the top of the Nailer. See FIGURE 1.
5. Position the nail on the workpiece and press the nail into the workpiece 2 to 6 times, or until
the nail is completely nailed in.
6. When you are finished nailing, immediately disconnect the air hose.
Maintenance
1. Wipe down the Nailer with a lint free cloth.
2. Make sure the Guide Box (#18) and the Air Inlet are free from any dirt or debris.
Grip palm over top.
Guide Box (#18)
Air Inlet on back side (not shown)
FIGURE 1
Caution: Do not point the Nailer toward any person, pet, or toward yourself.
Immediately after finishing work, disconnect the Nailer from the air source.