Hitachi 222104 - Manual (Page 2)

2 307906
Table of Contents
Warnings 2 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Installation 5 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Operation 8 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Troubleshooting 9 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Service 10 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Parts List 12 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Parts Drawing 13 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Dimensional Drawing 14 . . . . . . . . . . . . . . . . . . . . . . . . . .
Technical Data 14 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Performance Curves 15 . . . . . . . . . . . . . . . . . . . . . . . . . . .
Graco Standard Warranty 16 . . . . . . . . . . . . . . . . . . . . . .
Graco Information 16 . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Symbols
Warning Symbol
WARNING
This symbol alerts you to the possibility of serious
injury or death if you do not follow the instructions.
Caution Symbol
CAUTION
This symbol alerts you to the possibility of damage to
or destruction of equipment if you do not follow the
instructions.
EQUIPMENT MISUSE HAZARD
Equipment misuse can cause the equipment to rupture or malfunction and result in serious injury.
D
This equipment is for professional use only.
D Read all instruction manuals, tags, and labels before you operate the equipment.
D
Use the equipment only for its intended purpose. If you are not sure, call your Graco distributor.
D
Do not alter or modify this equipment. Use only genuine Graco parts and accessories.
D
Check equipment daily. Repair or replace worn or damaged parts immediately.
D Do not exceed the maximum working pressure of the lowest rated component in your system.
This equipment has a 180 psi (1.2 MPa, 12.4 bar) maximum working pressure at 180 psi
(1.2 MPa, 12.4 bar) maximum incoming air pressure.
D Use fluids and solvents that are compatible with the equipment wetted parts. Refer to the Techni-
cal Data section of all equipment manuals. Read the fluid and solvent manufacturer’s warnings.
D
Do not use 1,1,1–trichloroethane, methylene chloride, other halogenated hydrocarbon solvents,
or fluids that contain such solvents in pressurized aluminum equipment. Such use could result in
a chemical reaction, with the possibility of explosion.
D
Handle hoses carefully. Do not pull on hoses to move equipment.
D
Route hoses away from traffic areas, sharp edges, moving parts, and hot surfaces. Do not ex-
pose Graco hoses to temperatures above 82
_
C (180
_
F) or below –40
_
C (–40
_
F).
D Do not lift pressurized equipment.
D
Comply with all applicable local, state, and national fire, electrical, and safety regulations.
WARNING WARNING