Hitachi VT-MX4410A - Manual (Page 9)

PRECAUTIONS
9
PRECAUTIONS
LOCATION
For safe operation and optimum performance of your VCR, keep the following in mind
when selecting a place for its installation:
• Shield it from direct sunlight and keep it away from sources of intense heat.
• Avoid dusty or humid places.
• Avoid places with insufficient ventilation for proper heat dissipation. Do not block the
ventilation holes on the sides of the VCR. Do not place the unit on a carpet because
this will block the ventilation holes.
• Install unit in a horizontal position.
• Avoid locations subject to strong vibration.
• Do not place the VCR near strong magnetic fields.
• Avoid moving VCR to locations where temperature differences are extreme.
• Do not place the VCR directly on top of the TV.
POWER SUPPLY
• AC 120V, 60Hz ONLY
AVOID THE HAZARDS OF ELECTRICAL SHOCK AND FIRE
• Do not handle the power cord with wet hands.
• Do not pull on the power cord when disconnecting it from AC wall outlet. Grasp it by
the plug.
• If, by accident, water is spilled on your VCR, unplug the power cord immediately and
take the unit to our Authorized Service Center for servicing.
• Do not put your fingers or objects into the VCR cassette holder.
• Do not place anything directly on top of the VCR.
WARNING
Moisture condensation may occur inside the unit when it is moved from a cold place to a
warm place, or after heating a cold room or under conditions of high humidity. Do not use
the VCR at least for 2 hours until its inside is dry.
FCC WARNING-
This equipment may generate or use radio frequency energy. Changes