Heartland Toledo XT - Manual (Page 34)

Read all instructions before installing or using this appliance.
Installation Instructions
Save these instructions for future reference.
34
Leveling the Range
Place the range in its intended position taking care
not to twist it within the gap between the kitchen
units as damage may occur to the range or the
units. Install the oven shelves in the oven. Check for
levelness by placing a spirit level or a cup, partially
filled with water, on one of the oven grids. If using a
spirit level, take two
readings-with the level placed diagonally first in one
direction and then the other.
The rollers can be adjusted to level the range. To
adjust the height of the rear of the range use the
leveling tool supplied to turn the adjusting nuts at the
front bottom corners of the range.
Adjust the height of the front roller to level the range.
Turn clockwise to raise the range and counter
clockwise to lower.
When you are satisfied with the height and level raise
the front of the range by one turn of the front roller
adjuster. Screw down the front feet to meet the floor.
Screw the front roller adjuster counter clockwise to
raise the front roller so that the front of the range is
supported on the feet, not the front roller, to prevent
accidental movement of the range.
Leave the leveling tool in the storage drawer, so
that the customer can use it if they wish to move
the range.
Anti-Tip Device
WARNING
Range must be secured by Anti-Tip bracket supplied.
See instructions to install (supplied with bracket).
Unless properly installed, the range could be tipped
by leaning on the door. Injury might result from spilled
hot liquids or from the range itself.
Installing the Anti-Tip Device
The Anti-Tip bracket is supplied with instructions for
installation in a variety of locations. The instructions
include all necessary information to complete the
installation. Read the Safety Instructions and the
instructions that fit your situation before beginning
installation.
Gas Connection
Installation of this range must conform with local codes
or, in the absence of local codes, with the National Fuel
Gas Code, ANSI Z223.1-latest edition.
In Canada the range must be installed in accordance
with the current CGA Standard CAN/CGA-B149 -
Installation Codes for Gas Burning Appliances and
Equipment and/or local codes.
In The Commonwealth Of Massachusetts
This product must be installed by a licensed plumber or
gas fitter when installed within the Commonwealth of
Massachusetts.
A manual valve must be installed in an accessible
location in the gas piping, external to the appliance for
the purpose of turning on or shutting off the gas supply.
Gas Supply Requirements
Recommended Gas Pipe Outlet Locations
Opening inside the drawer cavity
Provide Adequate Gas Supply
Provide Adequate Gas Supply
Prior to installation, ensure that the local distribution
conditions (nature of the gas and gas pressure) and
the adjustment of the appliance are compatible.