Remote control code programming 12 13 – HONDA FIT Remote Control Transmitter User Manual

Page 11

Text mode
Original mode

Remote Control Code Programming

Press the “LOCK” or “UNLOCK” button on the
remote control transmitter.

• The power door locks cycle to indicate

programming mode.

• To terminate the programming mode at this

point, either turn the ignition key to the
“OFF” position or leave the remote’s button
untouched for over 10 seconds. To program
the remote, perform steps 2 through 12.

Press the “LOCK” button of each remote (one
at a line) to be stored in memory.

• The power door locks cycle to confirm

each entry.

• A button on each remote control transmitter

to be programmed must be pressed.
Perform the programming step within 10
seconds for each remote or else the
programming mode will terminate.

NOTE: Only 3 remotes can be stored in the
system’s memory.