haier HWM50-18 B - Manual (Page 7)

5
1. The height of the drain hose shall be
less than 10cm, or the drainage will not
be smooth, and cost such long time that
the machine may stop at mid way.
2. Do not trample or press the drain hose.
If the drain hose is too long, cut it at mid
point. To make smooth drainage, cut the
front end of the hose slantingly.
4. If extra drain hose is needed, please
make separate purchase. The inner
diameter of the extra hose shall not
less than 30mm, and the length shall
not exceed 1.5m.
If the extra hose is too long, cut it
either at A or at B point.
How to change the direction of the drain hose
Usage of the dr ain hose
The drain hose shall drain smoothly
1.Dismantle the back cover of the washing machine. 3.Dismantle the protecting cover of the drain outlet
at the other side (method the same as the bushing).
Install the bushing as per indicated in Figure 4.
4.Extend the drain hose from the other side. Fix the
drain hose onto the base frame with the drain hose
frame. (As indicated in Figure 5)
5.Install the protecting cover of the drain outlet
at the other side as per indicated in Figure 6.
Drain outlet
protecting cover
Drain hose bushing
Drain hose bushing
Figure 1
Figure 4 Figure 5
Figure 6
Drain hose
bushing
Take off Drain hose
bushing claw
Cabinet
Figure 2
Figure 3
Inner
Press
Press
Outer
2.Put down the drain hose. Take off the drain
hose frame. As indicated in Figure 1, put the
drain hose into the cabinet. Then stretch one
hand into the cabinet to nip the claw of the
drain hose bushing to remove the claw from
original position. Take off the drain hose
bushing with the other hand. (As indicated in
Figure 2 and 3).
Drain hose frame
Outer
drain
hose
Attention: To guarantee the proper installation, it is suggested to have the direction changing of drain
hose performed by the after-sales service technicians of our company.