Harbor Freight Tools 45725 - Manual (Page 7)

Page 7
SKU 45725
Operation (continued)
6. When you finish sanding or grinding, turn the Neutral / Direction Switch to neutral and wait
until the wheel comes to a complete stop. Turn off the On / Off Switch. See Figure 1.
7. If you wish to switch rotation direction without turning off the machine, turn
the
Neutral / Direction Switch to neutral and wait until the wheel comes to a complete stop, and
then turn switch to the opposite direction.
Maintenance
Warning! Make sure your Sander / Grinder is unplugged before attempting any
maintenance.
1. Remove your vacuum hose (not included) from the vacuum port and clean out port.
2. Clean the surface of the Sander / Grinder with a clean cloth or soft dry brush.
3. Check all nuts and bolts for tightness. Tighten if necessary.
4. Check sanding disk for tears or frays. Replace if necessary.
5. Clean debris from 3/4” miter slot.