Hayter Mowers Condor hydrostatic Drive 510D - Manual (Page 28)

1.28 1.28 OPERATING THE MOWER
Adjusting Height of Cutter continued
30’’ Rotary Attachment.
Loosen hand knob (1) sufficiently to allow lever
(2) to be moved to the required height of cut posi-
tion. Retighten the hand knob to secure the height
of cut lever in position.
Handlebar Height Adjustment
The height of the handlebar may be adjusted at the
connection between the handlebar stays (1) and
the plate on the handlebar (2). Adjustment holes
(3) provide 3 alternative handlebar settings. Ensure
that the handlebars are set at the same level on each
side of the mower.
Note: The length of the connecting rods to the
travel control rocker levers must be re adjusted as
necessary to ensure correct operation.
1. Hand knob
2. Height of Cut Lever
1. Handlebar Stay
2. Handlebar
3. Adjustment Holes