Harbor Freight Tools 98904 - Manual (Page 3)

SKU 98904 for technical questions, please call 1-800-444-3353 Page 3
assembly
1B
Figure 1
1. Remove the contents in the small plastic bag and locate Nipple (1B). Thread the Nipple (1B) into the
side port of the Filter Cap (2A). You should use pipe thread seal tape or pipe dope (not included) on all
threaded connections. See Figure 1.
stay alert 13. . Watch what you are doing, use common sense. Do not operate any tool when you are tired.
check for damaged parts 14. . Before using Filter/Regulator, any part that appears damaged should be
carefully checked to determine that it will operate properly and perform its intended function. Check for
alignment and binding of moving parts; any broken parts or mounting fixtures; and any other condition that
may affect proper operation. Any part that is damaged should be properly repaired or replaced by a qualified
technician. Do not use any air tool if its switch does not turn On and Off properly.
replacement parts and accessories
15. . When servicing, use only identical replacement parts. Use of any
other parts will void the warranty.
Do not operate air tools if under the influence of alcohol or drugs
16. . Read warning labels if taking
prescription medicine to determine if your judgment or reflexes are impaired while taking drugs. If there is
any doubt, do not operate the product.
Maintenance
17. . For your safety, service and maintenance should be performed regularly by a qualified
technician.
Before using any air tool, read and adhere to all instructions and safety warnings provided in the
18.
instruction manual of the air compressor being used. Be sure to use compressed air only.
Warning: the brass components of this product contain lead, a chemical known to the state of california
to cause birth defects (or other reproductive harm). (california health & safety code 25249.5 et seq.)
Warning: the warnings, cautions, and instructions discussed in this instruction manual cannot cover
all possible conditions and situations that may occur. it must be understood by the operator that com-
mon sense and caution are factors which cannot be built into this product, but must be supplied by the
operator.
unpacking
When unpacking, check to make sure all parts are included. Refer to the photo below, and the Parts List and
Diagram located at the end of this manual. If any parts are missing or broken, please call Harbor Freight Tools
at the number on the cover of this manual.
2A