Harbor Freight Tools 94487 - Manual (Page 4)

Page 4 For technical questions, please call 1-800-444-3353. SKU 94487 95553
Symbols and Specific
Safety Instructions
Symbol Definitions
Symbol Property or statement
PSI
Pounds per square inch of pressure
CFM
Cubic Feet per Minute flow
SCFM
Cubic Feet per Minute flow
at standard conditions
NPT
National pipe thread, tapered
NPS
National pipe thread, straight
WARNING marking
concerning Risk of Eye Injury.
Wear ANSI-approved eye protection.
WARNING marking concerning Risk of
Hearing Loss. Wear hearing protection.
WARNING marking concerning
Risk of Respiratory Injury. Wear
NIOSH-approved dust mask/respirator.
WARNING marking concerning
Risk of Explosion.
Specific Safety Instructions
1. Failure to heed these markings may result in
personal injury and/or property damage:
2. Study, understand, and follow all instructions
before operating this device.
3. Do not exceed rated capacity.
4. Use only on hard, level surfaces.
5. Lifting device only. Immediately after lifting,
support the vehicle with appropriate means.
6. Do not adjust safety valve.
7. Wear ANSI-approved safety goggles and
heavy-duty work gloves during use.
8. Keep clear of load while lifting and lowering.
9. Lower load slowly.
10. Do not use for aircraft purposes.
11. Apply parking brake and chock
tires before lifting vehicle.
12. Lift vehicle only at
manufacturer-recommended locations.
13. Inspect before every use; do not use
if parts loose or damaged.
14. Do not exceed 120 PSI air pressure.
15. Maintain labels and nameplates on Bottle Jack.
These carry important safety information.
If unreadable or missing,
contact Harbor Freight Tools for a replacement.
16. Bleed the hydraulic system before its initial use.
17. Do not leave tool unattended when it is
connected to a compressed air supply.
Release tool’s load, and disconnect from
compressed air supply before leaving.
18. This product is not a toy.
Keep it out of reach of children.
19. When lifting only one wheel, make sure to
support load immediately with one jack stand
(not included) placed under side of vehicle being
lifted. Align saddle of jack stand directly under
vehicle’s seam or recommended lifting point.
20. When lifting entire front end or rear end of
vehicle, make sure to support load immediately
with two jack stands. Align saddles of jack
stands directly under vehicle’s frame or
recommended lifting points. Also, make sure
jack stands are adjusted at the same height.
21. Do not use Bottle Jack with the vehicle’s
engine running. When running, the vehicle’s
engine produces carbon monoxide, a colorless,
odorless, toxic fume that, when inhaled,
can cause serious personal injury or death.
22. Keep hands and feet away from all moving
parts of the Bottle Jack when applying or
releasing a load. Keep people and animals at
a safe distance when using the Bottle Jack.
23. Do not allow anyone in vehicle
when using Bottle Jack.
24. Do not use Bottle Jacks to lift both ends
of a vehicle at the same time.
25. Before lowering the Bottle Jack, make sure
tool trays, jack stands, and all other tools and
equipment are removed from under the vehicles.
26. The warnings, precautions, and instructions
discussed in this manual cannot cover all
possible conditions and situations that may occur.
The operator must understand that common sense
and caution are factors, which cannot be built into
this product, but must be supplied by the operator.
SAVE THESE
INSTRUCTIONS