Hitachi DV PF74U - Manual (Page 16)

– 16 – EN
1L25
6 After scanning, the tuner stops on the low-
est memorized channel. The TV screen
returns to TV mode.
¡ If “AUTO SET UP” appears on the TV screen again,
check the cable connections. Press
B once again and
the DVD/VCR will begin preset again.
AUTOMATIC CHANNEL SET UP
SETUP
You can automatically program the tuner to scan only
the channels you receive in your area.
¡ Channel memory programming is NOT needed when
you connect the DVD/VCR to a cable box or a satel-
lite box as in "DVD/VCR TO TV CONNECTION"
on page 14. In this case, select channel 3 on your TV.
Then, the channel you want to record or view may be
selected at the cable box or satellite box.
¡ If noise appears, change the RF output channel of
the DVD/VCR to channel 4 by pressing PLAY for
3 seconds during playback. Then select the same
channel (CH4) on your TV.
¡ Follow the steps below once. Repeat only if there is
a power failure or if the DVD/VCR is unplugged for
more than 30 seconds. (In these cases, the pro-
grammed channels are erased.)
¡ You must follow the steps below before attempting
to play or record a video tape. If you want to play
or record a video tape BEFORE programming the
tuner, you can cancel it by pressing
CLEAR/C.RESET.
1 You need to connect the antenna or cable to
the DVD/VCR first. Then, connect the
DVD/VCR power plug to a standard AC outlet.
2 Turn on the TV and set the TV to channel 3.
¡ If noise appears, change the RF output channel of
the VCR to channel 4 by pressing PLAY for 3 sec-
onds during playback. Then select the same chan-
nel (CH4) on your TV. (See “RF Output Channel”
on page 14 for more details.)
3 Turn on the DVD/VCR by pressing y/I.
4 Select the On Screen Language (“ENG-
LISH”, “FRANCAIS” or
“ESPAÑOL”) by pressing K
or L. Then, press B.
5 Begin channel preset by pressing B once.
The tuner scans and memo-
rizes all active channels in
your area.
¡ The DVD/VCR distinguishes
between standard TV channels
and cable channels.
VCR
TO SELECT A DESIRED CHANNEL
You can select the desired channel by using CH (o/p)
or by directly entering channel numbers using the
Number buttons.
Note for using the Number buttons:
¡ When selecting cable channels which are higher
than 99, enter channel numbers as a three-digit num-
ber.(For example: 117, press 1,1,7)
¡ You must precede single-digit channel numbers with
a zero (For example: 02, 03, 04 and so on).
TO PRESET THE CHANNELS AGAIN
1 Press MENU until the main menu appears.
2 Select “CHANNEL SET UP” by pressing K
or L. Then, press B.
3 Select “AUTO SET UP” by pressing K or L.
Then, press B.
¡ After scanning, the tuner stops on the lowest memo-
rized channel.
LANGUAGE SELECT
ENGLISH [ON]
FRANCAIS
ESPAÑOL
AUTO SET UP
CH 01
H9651UD.qx3 04.3.2 8:54 PM Page 16