Hasbro Transformers 83638 - Manual (Page 2)

TO REPLACE BATTERIES:
Use a Phillips/cross head screwdriver (not included) to loosen screw in battery
compartment door (screw remains attached to door). Remove door and discard
old batteries. Insert 2 x 1.5V fresh “AA” or R6 size batteries. Alkaline batteries
recommended. Replace door and tighten screw.
IMPORTANT:
BATTERY INFORMATION
Please retain this information for future reference.
Batteries should be replaced by an adult.
CAUTION:
1. Always follow the instructions carefully. Use only batteries specified and be
sure to insert them correctly by matching the + and – polarity markings.
2. Do not mix old batteries and new batteries, or standard (carbon-zinc) with
alkaline batteries.
3. Remove exhausted or dead batteries from the product.
4. Remove batteries if product is not to be played with for a long time.
5. Do not short-circuit the supply terminals.
6. Should this product cause, or be affected by, local electrical interference,
move it away from other electrical equipment. Reset (switching off and back
on again or removing and reinserting batteries) if necessary.
7. RECHARGEABLE BATTERIES: Do not mix these with any other types of bat-
tery. Always remove from the product before recharging. Recharge batteries
under adult supervision. DO NOT RECHARGE OTHER TYPES OF BATTERIES.
CAUTION:
TO AVOID BATTERY LEAKAGE
1. Be sure to insert the batteries correctly and always follow
the toy and battery manufacturers’ instructions;
2. Do not mix old batteries and new batteries or alkaline,
standard (carbon-zinc) or rechargeable (nickel-cadmium)
batteries;
3. Always remove weak or dead batteries from the product.
FCC STATEMENT
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation. This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to pro-
vide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy, and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or televi-
sion reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician for help.
CAUTION: Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
CHANGING TO ATTACK MODES
1 2 3
5 4
1 2 3
4
Press button
for phrases
and sounds!
5 6
Press button for
lights and sounds!
HEADMASTER ™
can attach to robot!
(HEADMASTER ™
sold serperatley.)