H-P Products Electric Powerhead Electroglide - Manual (Page 8)

Light Bulb Replacemnent
1. Disconnect cleaner from
electrical outlet.
2. Remove light cover by pressing
in and lifting both sides of
cover as shown.
WARNING
Always unplug electrical cord and vacuum hose before
servicing and maintaining the Electroglide Electric
Powerhead. Failure to do so could result in electrical shock
or personal injury from cleaner suddenly starting. Always
follow all safety precautions specified when caring
for your Electroglide.
MAINTENANCE AND CARE
3. Push in and turn bulb counter
clockwise to remove.
4. Replacement bulb must not be
higher than 15 watts
(Part #7967).
5. Close light cover until it snaps
in place.
Brush Cleaning
Check the brush roll and brush support areas frequently in order to
maintain optimum efficiency. If hair, string, thread, carpet fiber or lint
becomes wound around the brush roll, remove by unwinding them by
hand or carefully cutting with scissors. If buildup becomes excessive,
disconnect the Electroglide Powerhead from the wand assembly and
follow the Brush Replacement steps on Page 11. Instructions can also
be found under the light cover.
8 ELECTROGLIDE
Push In
And Turn