Unpacking, Assembly instructions – Harbor Freight Tools CHICAGO 96325 User Manual

Page 9

Page 9

SKU 96325

for technical questions, please call 1-800-444-3353.

unPacking

When unpacking, check to make sure that the item is intact and undamaged. If any

parts are missing or broken, please call Harbor Freight Tools at the number shown on the
cover of this manual as soon as possible.

assembly instructions

note: For additional information regarding the parts listed in the following pages, refer to

the Assembly Diagram near the end of this manual.

Warning! Make sure the On/Off Button (2) is depressed and that the Vacuum

is unplugged from an electrical outlet before assembling the Vacuum.

Install one Cap Nut (32) onto the Axle (30). Use a rubber mallet (not included) to
gently tap the Cap Nut until it
is firmly seated. Slide one
Wheel (31) onto the Axle until
it rests against the Cap Nut
just attached.

Slide the Axle through the
Large Wheel Base (29), and
attach the other Wheel and
Cap Nut onto the Axle as de-
scribed above.

Press the Wheel Covers
(33) onto the outside of each
Wheel.

Align the Large Wheel Base
with the bottom edge of the
Canister on the opposite side
from the Drain, and push down
to lock the Large Wheel Base
onto the Canister. Make sure
both Wheels spin freely.

Align the Small Wheel Base (22) with the bottom edge of the Canister on the same
side as the Drain and push down to lock the Small Wheel Base onto the Canister.

Insert Casters (23) into each side of the Small Wheel Base.

Push the Storage Box (27) firmly onto the top of the Large Wheel Base.

Slide the Metal Handle (24) into the Container Handle (28) on each side of the
Canister and secure with Screws (20). Do not overtighten.

vacuum shown assembled

Wheel (31)

storage
box (27)

metal
Handle (24)

small Wheel
base (22)

casters (23)

drain

vacuuming tools

container
Handle (28)

Wet/dry
vacuum
connection

latch

vacuum

assembly