Harbor Freight Tools CHICAGO 96325 - Manual (Page 12)

Page 12 SKU 96325 for technical questions, please call 1-800-444-3353.
The Vacuum must be emptied into a proper waste fluid drain before continuing use.
Remove the Drain Cover (21) to empty the Vacuum, replace the Drain Cover, and
resume work.
It is recommended Vacuum be thoroughly rinsed with clean water after each use.
using the vacuum for dry applications:
WARNING! Make sure the Off Button (2) is depressed before plugging the
Vacuum into a standard 120V outlet.
Attach the appropriate attachment to vacuum. If the unit becomes full or clogged
the Indicator Light (4) will turn on:
Check and change Dust Bag if necessary.
Clean dirt out of Hose or other accessories.
Clean HEPA Filter.
Resume job, clean Vacuum when finished.
blower
note: When using Vacuum as blower, special attention
should be paid to safety. Always wear ANSI-
approved goggles and dust mask. Clear the
area of children and bystanders to make sure
they are not harmed by flying dirt or debris.
Connecting the Hose to the Exhaust allows
the Vacuum to be used as a blower.
Find blower port at back of Assembly Cover (5).
Connect the desired attachment, and push the On Button (3)
Clean the desired area, push the Off Button (2), and clean the Vacuum.
insPection, maintenance, and cleaning
Warning! Make sure the Off Button (2) is depressed and that the Vacuum is
unplugged from its electrical outlet before performing any inspection, maintenance,
or cleaning procedures.
before eacH use, inspect the general condition of the Vacuum. Check for loose
screws, misalignment or binding of moving parts, cracked or broken parts, dam-
aged electrical wiring, and any other condition that may affect its safe operation. If
abnormal noise or vibration occurs, have the problem corrected before further use.
do not use damaged equipment.
6.
7.
1.
2.
•
•
•
4.
1.
2.
3.
4.
1.
2.
Blower Port