Hitachi VT-M181A - Manual (Page 12)

Getting Started - 12 -
take it from where it comes in on the wall.
2. Considering the three pictures below, determine which adapter you will need to hook
it into your VCR.
If you have Use this adapter
Single 300 ohm flat wire
Separate UHF and VHF antenna
antenna wires, both 300 ohm
flat wire
300 ohm flat UHF and 75 ohm
round VHF
If you have "rabbit ears" (an antenna on top of your TV), you will need an additional
adapter and 75 ohm extension to make your leads reach from the antenna to the VCR.
This connection will work only if you have a strong, clear picture on the TV, indicating a
strong signal. Connect the antenna to the adapter, and use the cable extension to go
from the adapter to the VCR. Use the supplied 75 ohm cable to connect the VCR to the
TV.
Now continue with the hookup:
1. Using whichever adapter you have fit your antenna with, attach that connector to the
IN FROM ANT lower jack on the back of the VCR.