Haan GS-30 - Manual (Page 14)

pg 12 877-HAAN DIRECT / 877-422-6347 www. HAANUSA.com
Fig 3
ON
Fig 4
Fig 6
Fig 7
Using Your Garment Steamer
Operating Instructions:
(cont)
5) Align the cap and screw it on securely. Be sure
to get it tight.To avoid any leakage or dripping,
we recommend that you carry it back to the base
with the cap up rather than by the handle.
6) Hold the Reservoir Tank over the recess in the base
and turn it over so the cap is now facing down.
Hold the handle and insert the Reservoir Tank,
aligning the cap as you lower it into the recess
and over the Water Release Prong in the center.
note: in the center of the recess there is a black
prong standing upright that fits into the cap. there
is a spring activated stopper that seals the water
into the tank. When you fit the Water release prong
(Fig 3) into the cap it opens this stopper and
releases the water into the base where the steam
will be generated.
7) Plug the unit into a grounded wall outlet. Press
the Power Button to turn the unit on. (Fig 4a)
Upon pressing the Power Button, the Power Light
will illuminate to indicate the power is ON. (Fig 4b)
8) The unit will heat up in less than 40 seconds.
Once you see that a steady steam vapor is emitted
from the steam head, the Garment Steamer is ready.
9) With the Steam Wand hanging from the prongs of
the Cradle, align the shoulders of your garment on
the hanger and allow it to hang freely. (Fig 5)
10) Hold the wand of the steam head firmly and
slowly move it up and down, and then across the
garment surface until the wrinkles are removed
to your satisfaction. Always keep the steam head
positioned with the steam jets pointing away from
you and horizontal to the garment surface. (Fig 6)
One full tank of water will provide 60 minutes
of steam. Rest the Steam Wand in the Cradle when
changing garments.
11) When there is no more water in the tank, the Water
Refill Indicator Light will light up. (Fig 7) Hang the
steam head in the resting prongs. Turn your Garment
Steamer off and unplug the unit. Refill the orange
Removable Reservoir Tank as directed in Steps 1-5,
plug the unit in and continue steaming as before.
Water Release
Prong
a)
b)
Power
Light
Fig 5
Water
Refill
Light