Harbor Freight Tools 46092 - Manual (Page 8)

SKU 46092 For technical questions, please call 1-800-444-3353. Page 8
LENS AND HELMET MAINTENANCE
1. Replace the Front Lens Cover (1) if it is damaged
(cracked, scratched, soiled or pitted).
a. Remove the Front Lens Cover (1) by gently pulling up the
central part of the Lens -see
Figure 2, right.
b. Remove the protection film from both sides of the new Lens
if it comes with the film on. Place the new Lens into the right
position by bending it
slightly, enough to fit in between the
tabs at each side of the lens and putting the lens in place -
see
Figure 2 .
c. Check and make sure that the Lens is securely installed.
2. Clean the Filter Lens with a clean lint-free tissue or cotton cloth.
3. Don’t immerse the lens in water or any other liquid. Never use abrasives, solvents or oil
based cleaners.
4. Don’t remove the auto-darkening filter from the Auto-Darkening Welding Helmet. Never
try to open the filter.
5. Storage temperature: -13 to 167° F.
Shade Guide Chart
Figure 2