Harbor Freight Tools 46092 - Manual (Page 7)

SKU 46092 For technical questions, please call 1-800-444-3353. Page 7
COMMON PROBLEMS AND REMEDIES
1. Irregular Darkening or Dimming
a. Headband has been set unevenly on the two sides of the helmet (unequal distances
from the eyes to the filter’s lens).
b. Reset headband to reduce the difference in distances to filter, if necessary.
2. Auto-Darkening Filter Does Not Darken Or Flickers
a. Front Cover Lens is soiled or damaged (change the cover lens).
b. Sensors are soiled (clean surface of the sensors).
c. Welding current is too low (turn the switch to the “SLOW” position, if necessary.
3. Slow Response
a. Operating temperature is too low (do not use at temperatures below 23° F).
4. Poor Vision
a. Front/Inside Cover Lens and/or filter soiled (change it).
b. Insufficient ambient light.
c. Shade number is incorrectly set (reset shade number).
5. Welding Helmet Slips
a. Headband is not adjusted properly (must be lowered).
WARNING: You must stop using the Auto-Darkening Welding
Helmet IMMEDIATELY if any of the above mentioned
problems can’t be corrected.