Homelite UT41110 - Manual (Page 13)

Page 1 — English
Fig. 12
SPooL
RETAInER
SLoTS
SPooL
MAINTENANCE
TABS
SPooL
Fig. 13 HoLE
WInD CLoCKWISE
SPooL
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which may result in serious personal
injury.
Periodically, clean all foreign material from the trimmer head
vents.
You can often make repairs described here. For other repairs,
have the trimmer serviced by an authorized service dealer.
SPOOL REPLACEMENT
See Figure 1.
Use only .065 in. diameter monofilament string. Use original
manufacturer’s replacement string for best performance.

Unplug the string trimmer.
 Push in tabs on side of spool retainer.
 Pull spool retainer up to remove.
 Remove spool.
 To install the new spool, make sure the two strings are
captured in the slots opposite each other on the new
spool. Make sure the end of each string is extended
approximately 6 in. beyond each slot.
 Install the new spool so that the strings and slots align
with the eyelets in the string head. Thread the strings into
the eyelets.
 Pull the strings extending from the string head so the
string releases from the slots in the spool.
 Reinstall the spool retainer by depressing tabs into slots
and pushing down until spool retainer clicks into place.
STRING REPLACEMENT
See Figures 1 - 1.

Unplug the string trimmer.
 Remove the spool from the string head.
NOTE: Remove any old string remaining on the spool.
 Cut two pieces of string, each being approximately 9
ft. (2.7 m) long. Use only .065 in. (1.65 mm) diameter
monofilament string.
 Insert the first string into the anchor hole in the upper part
of the spool. Wind the first string around the upper part of
the spool counterclockwise, as shown by the arrows on
the spool. Place string in the slot on upper spool flange,
leaving about 6 in. (152 mm) extended beyond the slot.
Do not overfill. After winding the string, there should be
at least 1/4 in. (6 mm) between the wound string and the
outside edge of the spool.
 Repeat above step with second string, using the bottom
part of spool. Do not overfill.
 Replace the plastic retainer, spool, and the spool retainer.
Refer to Spool Replacement earlier in this manual.
STORING THE TRIMMER
 Depress telescoping boom coupler and set at shortest
setting.
 Clean all foreign material from the trimmer.
 Store it in a place that is inaccessible to children.
 Keep away from corrosive agents such as garden
chemicals and de-icing salts.