Homelite UT41110 - Manual (Page 11)

Page 11 — English
2
2
1
PUSH
180° 2
1
2 180°
1
OPERATION
WARNING:
Always hold the string trimmer away from the body
keeping clearance between the body and the string
trimmer. Any contact with the string trimmer cutting head
while operating can result in serious personal injury.
ADVANCING STRINGS
NOTE: The trimmer is equipped with an auto-feed head.
Bumping the head to try to advance the string will damage
trimmer and void warranty.
 With the trimmer running, release the switch trigger.
 Wait two seconds, and press the switch trigger.
NOTE: The strings will extend approximately 1/4 in. with
each stop and start of the switch trigger until the strings
reach the length of the grass deflector blade.
 Resume trimming.
ADVANCING THE STRINGS MANUALLY
Disconnect the string trimmer from the power supply, then
push the spool retainer button in while pulling on strings to
manually advance the strings.
CUT OFF BLADE
This trimmer is equipped with a cut-off blade on the grass
deflector. For best cutting, advance strings until they are
trimmed to length by the cut-off blade. Advance strings
whenever you hear the engine running faster than normal,
or when trimming efficiency diminishes. This will maintain
best performance and keep strings long enough to advance
properly.
CUTTING TIPS
See Figure .

Keep the trimmer tilted toward the area being cut; this is
the best cutting area.
 The string trimmer cuts when passing the unit from left
to right. This will avoid throwing debris at the operator.
Avoid cutting in the dangerous area shown in figure 8.
 Use the tip of the string to do the cutting; do not force
string head into uncut grass.
 Wire and picket fences cause extra string wear, even
breakage. Stone and brick walls, curbs, and wood may
wear strings rapidly.
 Avoid trees and shrubs. Tree bark, wood moldings, siding,
and fence posts can easily be damaged by the strings.
DAngERoUS
CUTTIng AREA
BEST CUTTIng AREA
DIRECTIon
oF
RoTATIon
Fig. 7
Fig. 8
TELESCOPING BOOM
See Figure .
The boom can be extended or shortened for ease of use.

Unplug the string trimmer.
 Unscrew telescoping boom coupler and slide to desired
position.
 Tighten telescoping boom coupler.
2
2 1 PUSH
180° 2 1
2 180° 1
TELESCoPIng
BooM CoUPLER