How to load your dishes, Ishwasher – Hotpoint D C 27 User Manual

Page 4

HOTPOINT - Instructions for installation and use

ISHWASHER

How to load your dishes

First of all.

Before placing the dishes in the

racks, remove the largest scraps

of food left over on your plates,

you will thus avoid blocking the

filter, which would reduce the

efficacy of the wash.

If the saucepans and frying pans

are very dirty, allow them to soak

before being washed. To make it

easier to load your dishes, pull the

racks out.
What goes into the

lower rack?

We recommend you place the

most difficult dishes to wash into

the lower rack: saucepans, lids,

soup dishes and plates (a load

example is shown in the photo).

 Serving dishes and large

lids: place them on the sides

of the rack.

 Saucepans, salad bowls:

must always be placed upside

down

 Very deep dishes: place

them obliquely, thus allowing

water to run down them and

cleaning them better

Place the cutlery with the handles

at the bottom; if the basket is the

one with side inserts, then insert

the tea spoons one by one into the

slots (see figure A).

It is best if you place longer utensils

horizontally at the front of the

upper rack.

After loading the dishes, remember

to check that the blades on the

sprayer arms can turn freely

without hitting against any dishes.

What goes into the

upper rack?

Place delicate and lightweight

dishes in the upper rack: glasses,

tea cups and coffee cups, saucers -

but plates too - shallow salad bowls,

slightly dirty frying pans and

shallow pans.

Position lightweight dishes in such

as way as to avoid their being

moved by the spray of water.
How to adjust the top

rack.

The upper rack can be set in high

or low position to enable you to

organise your dishes effortlessly.

Before washing, a few small steps can help you get a better wash and keep your dishwasher for longer.

Remove the largest scraps of food left over on your plates, soak saucepans and frying pans with tough

incrustations. After loading your dishes, make sure the blades on the sprayer arm turn well

Fig. A

upper rack

lower rack

Load examples

upper rack

lower rack

Open the rail stop flaps and pull the
rack out completely. Now place it in
high or low position, then slide it
along the guide rails until the front
wheels also go in. Now close the rail
stop flaps. Follow the sequence of
actions illustrated in figure "F".

Fig.F