Maintenance and servicing – Harbor Freight Tools 90168 User Manual

Page 11

SKU 90168

For technical questions, please call 1-800-444-3353.

Page 11

MaintenanCe and

seRViCing

Procedures not specifically

explained in this manual

must be performed only by a

qualified technician.

tO PReVent

seRiOus injuRY

FROM aCCidental

OPeRatiOn:

turn the Power switch of the

compressor to its “OFF”

position and unplug the

compressor from its electrical

outlet before performing any

inspection, maintenance, or

cleaning procedures.
tO PReVent seRiOus

injuRY FROM COMPRessOR

FailuRe:

do not use damaged

equipment. if abnormal noise

or vibration occurs, have the

problem corrected before

further use.

BeFORe eaCH use,

inspect the

general condition of the Air Compres-

sor. Check for loose screws, mis-

alignment or binding of moving parts,

damaged electrical wiring, Tank, air

hoses/accessories (not included),

and any other condition that may af-

fect its safe operation.
at end OF eaCH WORKdaY:

Condensation will accumulate inside

the Tank (14). To prevent corrosion

inside the Tank, the moisture should

be drained at the end of each work-

day. To drain the moisture, Pull the

ring on the Safety Valve (3) to relieve

all remaining air pressure in the Tank.

Open the Drain (9) on the bottom of

the Tank, and tilt the Tank to allow the

moisture to drain. Then, make sure

to fully close the Drain.
tO Clean:

Use a clean cloth and

mild detergent to clean the body

of the Air Compressor. Do not use

solvents. Do not immerse any part of

the Air Compressor in liquid.

WaRning! if the supply cord of

this power tool is damaged, it must

be replaced only by a qualified

service technician.