Harbor Freight Tools CONTRACTOR 92359 - Manual (Page 8)

Page 8 For technical questions, please call 1-800-444-3353. SKU 92359
FUNCTIONAL DESCRIPTION
Specifications
Operating Air
Pressure
65-90 PSI Maximum
Air Inlet 1/4” -18 NPT
Fastener
Capacity
.120” Dia. Shank, 3/4” to 1-3/4” L,
(120 capacity)
Air
Consumption
2 SCFM @ 90 PSI
7 SCFM (For Continuous Use)
Safety Full Sequential Safety
Accessories
Carrying Case
Air Tool Oil
Hex Wrenches (3mm, 4mm, 5mm)
ANSI-Approved Safety Goggles
Nail Coil (7/8” Nails)
Safety Nosepiece - Also called the
workpiece contact, the Safety
Nosepiece helps prevent the tool
from firing unless it is pressed against
an object.
INITIAL TOOL SET UP/
ASSEMBLY
Read the ENTIRE IMPORTANT
SAFETY INFORMATION
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
Note: For additional information regarding
the parts listed in the following pages,
refer to the Assembly Diagram near
the end of this manual.
Unpacking
When unpacking, make sure that the
item is intact and undamaged. If any parts
are missing or broken, please call Harbor
Freight Tools at 1-800-444-3353 as soon
as possible.
• This air tool may be shipped with a
protective plug covering the air inlet.
Remove this plug before set up.
Air Supply
TO PREVENT
EXPLOSION:
Use only clean, dry, regulated,
compressed air to power this
tool. Do not use oxygen,
carbon dioxide, combustible
gases, or any other bottled
gas as a power source for this
tool.
Quick
Coupler
Recommended Air Line Components
Regulator with
Pressure Gauge
Quick
Coupler
Air Hose
on Reel
Valve Filter Oiler
Coupler
Plug
Tool
Air
Compressor
Coupler
Plug
1. Incorporate a filter, regulator with
pressure gauge, oiler, in-line shutoff
valve, and quick coupler for best
service, as shown in the diagram
above. An in-line shutoff ball
valve is an important safety device
because it controls the air supply
even if the air hose is ruptured.
The shutoff valve should be a ball
valve because it can be closed
quickly.
REV 09e