haier ESA3067 - Manual (Page 13)

Timer off ( See Fig. #5)
The unit must be running to set time off. Use this to preset the time you would like the
unit to shut off.
a) Press TIMER OFF. LED display will show "XX" (time set last time).When power is connected
for the first time, LED display will show "01".
b) Set desired number by pressing the ( ) pad of the Temp/Time buttons, once for each
hour. If you pass the desired time, use the ( ) pad key to lower the selection.
c) After you set TIMER OFF, LED display will show the room temperature about 5 seconds
later. When using the timer, the unit will revert to the last COOL and FAN settings when
activated. The timer must be reset every time you choose to use it.
OFF FAN
COOL ON HIGH
LOW
MODE SPEED TIMER
POWER
ON/OFF
TEMP / TIME
MODE SPEED TIMER
POWER
TEMP / TIME
OFF FAN
COOL ON HIGH
LOW
MODE SPEED TIMER
POWER
ON/OFF
TEMP / TIME
OFF COOL ONLY
FAN ONLY ON HIGH
MED
DEHUM
ENERGY
SAVER LOW
ON/OFF
11
Timer On or Timer Off mode is used to pre-start or shut off your unit in advance. You
can program this up to 24 hours in advance. You can use the Timer in 4 functions, i.e.
COOL, ENERGY SAVER, DEHUMID or FAN.
Timer on (See Fig.#5)
The unit must be on to set the timer. Unit will shut down automatically after it accepts the
settings in 5 seconds. Use this mode to pre-set the start time of the unit 24 hours in advance.
a) Press TIMER ON. LED display will show "XX" (time set last time). When power is connected
for the first time, LED display will show "01".
b) Set the desired number of hours by pressing the ( ) pad of the Temp/Time buttons,
once for each hour. If you pass the desired time, use the ( ) pad key to lower the selection.
c) After you set TIMER ON, LED display will show the time. This time displayed means:
the unit will starts after X hours.