Hotpoint 6685X - Manual (Page 14)

14
CHAPTER 2 – USING THE CONTROLS AND MODES
2.1 SETTING THE CLOCK (for key references see page 7)
• When the appliance is connected to the domestic power supply for the first time, or after a power cut,
four dashes will appear on the display (----).
In order to set the clock, proceed as described below:
Press the key (6).
(The hours flash on display 1)
1
Set the desired time by turning
the
knob (14).
(The hours flash on display 1)
2
Press the key (6) again.
(The minutes flash on display 1)
3
Set the desired minutes by
turning the
knob (14)
(The minutes flash on display 1)
4
Press the key (6) again.
(The display shows the time set)
5
• If you wish to change the hour on the dial once it has been set, press the key (6) before pro-
ceeding to set the new time as described above.
• It is possible to display the current time even after starting the mode set, by pressing the key (6)
(the time is displayed for 2 seconds).